Smart Switch Gen5
Smart Switch. There are appliances that we turn on and off in our homes each day. And despite the fact that it'd save us money, there are those that we could turn off only it was easier. Smart Switch Gen5 give convienience, control and money saving considerations into one, small, plug-in tool. A tool that can be programmed, scheduled, controlled and communicated with from anywhere in the world.
100% Secure Payments
Australian Wide Flat Rate Delivery
Smart Switch Gen5 is a low-cost Z-Wave appliance switch which can report wattage energy usage or kWh energy usage over a period of time. It is designed to be controlled by other Z-Wave devices to turn ON/OFF to save electricity when appropriate. It can also report immediate wattage consumption or kWh energy usage over a period of time. The wireless module is powered from the mains supplys. In the event of power failure, non-volatile memory retains all programmed information relating to the units operating status. This device support secure communication when included by a controller that also supports secure communication. The device will then send all commands as secure commands unless the receiving device can not accept them. Then the command is send the normal way automatically.
Control a lamp or an appliance remotely
Plug-in Module installed directly between the wall outlet and the charge it has to control
ON/OFF function to control lights or appliances (no dim function)
Low-cost Z-Wave energy monitor and on/off appliance switch
Measuring instantaneous and cumulative consumptionControl of local charge via the built-in buttonStatus LED integrated on the button50% smaller than the original Aeon Labs Smart Switch Protection against overloadPart of Gen5 range of Aeon LabsSecured radio communication via AES-128 encryptionZ-Wave chip 500 seriesCommunication 250% faster compared to standard Z-Wave devicesOver the air firmware updates (OTA)Z-Wave message Repeater
Latest Z-Wave protocol and commands
Optimised antenna range up to 500 feet/150 metres outdoors
Designed and built with gateway partners and end-consumers in mind
Certified for Australia (FCC, CE, C-TICK, ROHS)
Z-Wave frequency: 921.42MHz (for Australian/New Zealand use)
230V 50Hz input, 2400W or 10A maximum output. 230V 50Hz, Max: 15A
Operating Distance: Up to 500 feet/150 metres outdoors.
- HomeSeer HS3/HS3PRO, with Z-Wave Plug-In (22.214.171.124)
- Vera UI7 Firmware
For Product Instruction Manual, please see the download section at the bottom of this page.